Use & Mixing

The instructions for use and mixing described below are from the Environmental Protection Agency approved Federal Label. Please click on 'Labels / MSDS' in the left hand navigation for special or state label instructions. Always read and follow label instructions.

Previcur Flex Fungicide

Reentry PPE
PPE required for early entry to treated areas that is permitted under the WorkerProtection Standard and that involves contact with anything that has been treated, such as plants, soil, or water, is:- Coveralls- Chemical-resistant gloves made of any waterproof material- Shoes plus socks
PERSONAL PROTECTIVE EQUIPMENT (PPE)Applicators and other handlers must wear:- Long sleeved shirt and long pants- Chemical-resistant gloves made of any waterproof material made of barrier laminate, butyl rubber => 14 mil, nitrile rubber => 14 mil, or neoprene rubber => 14 mil, natural rubber => 14 mil, polyethylene, polyvinyl chloride => 14 mil, or Viton => 14 mil.- Shoes plus socks
MIXING THE SPRAYIt is the pesticide user's responsibility to ensure that all products are registered forthe intended use. Read and follow the applicable restrictions and limitations anddirections for use on all product labels involved in tank mixing. Users must follow the most restrictive directions for use and precautionary statements of each product in the tank mixture.Follow the directions of your State Cooperative Extension Service for tank mixing with wettable powders, emulsifiable concentrates, suspension concentrates, or flowables. Add one-half of the required amount of water to the spray or mixing tank and start agitation. Add the required quantity of PREVICUR FLEX FUNGICIDE and the tank-mix partner to the water and complete filling with water to the required total volume. Maintain agitation throughout spraying. DO NOT allow spray mixture to remain in the tank overnight, or for long periods during the day without agitation.Consult the intended tank-mix partner product label for appropriate application rates and use instructions. Follow the label directions for the most restrictive of label precautions and limitations. This product may not be mixed with any product containing a label prohibition against such mixing. Read and observe the most restrictive precautionary statements and other information appearing on product labels used in mixtures.COMPATIBILITYPREVICUR FLEX FUNGICIDE is compatible with most commonly used fungicide, herbicide, insecticide, and foliar nutrient products. However, the physical compatibility of PREVICUR FLEX FUNGICIDE with all potential tank-mix partners has not been fully investigated. If tank mixing with other pesticides is desirable, conduct a jar test with the volumes and rates typically used in agricultural application. Using a small container of water, add the proportionate amounts of the products: wettable powders and water-dispersible granular products first, then liquid flowables and emulsifiable concentrates last. After thoroughly mixing, let stand for at least 15 minutes. Look for signs of separation, globules, sludge, flakes, or other precipitates. Physical compatibility is indicated if the combination remains mixed or can be remixed readily. THE CROP SAFETY OF ALL POTENTIAL TANK-MIXES WITH PREVICUR FLEX FUNGICIDE, INCLUDING ADDITIVES AND OTHER PESTICIDES HAS NOT BEEN TESTED ON ALL CROPS. BEFORE APPLYING ANY TANK-MIXTURE NOT SPECIFICALLY LISTED ON THIS LABEL, SAFETY TO THE TARGET CROP(S) MUST BE CONFIRMED.

Always read and follow label instructions. Not all products are registered for use in every state. Please check with Bayer or your local Lead State Agency for product registration status. If you wish to find out if a product is registered in your state or for additional product information, send us an email or call 1-866-99-BAYER.
Copyright © Bayer CropScience