Wolverine Advanced Herbicide
CROP PROTECTION

Wolverine Advanced Herbicide

Herbicide
Wolverine® Advanced herbicide provides cross-spectrum weed control by harnessing the power of herbicide Groups 1, 27 and 6, combined with maximum crop safety.
Approved In
CO, ID, MN, MT, ND, OR, SD, WA, WI, WY
    Group NumberFormulaRegistration Number
    GROUP HERBICIDE liquid0000264-01168-AA-0000000

    Active IngredientFormulation
    Bromoxynil Octanoate6.13 %
    Bromoxynil Heptanoate5.93 %
    fenoxaprop-p-ethyl4.56 %
    Pyrasulfotole1.50 %

Labels / MSDS
Additional Downloads

Use and Mixin

Use and Mixing

The instructions for use and mixing described below are from the Environmental Protection Agency approved Federal Label. Always read and follow label instructions. Not all products are registered for use in every state. Please check with Bayer or your local Lead State Agency for product registration status. If you wish to find out if a product is registered in your state or for additional product information, send us an email or call 1-866-99-BAYER.
      MIXING INSTRUCTIONS
      Order of Mixing Wolverine Advanced Herbicide must be applied with clean and properly calibrated equipment. Prior to adding Wolverine Advanced Herbicide to the spray tank, ensure that the spray tank, filters and nozzles have been thoroughly cleaned. In-line strainers and nozzle screens should be 50 mesh or coarser. 1. Fill the spray tank 1/4 to 1/2 full with clean water then add AMS or UAN and begin agitation or bypass. 2. Add the appropriate rate of Wolverine Advanced Herbicide directly to the spray tank. Maintain sufficient agitation during both mixing and application. 3. Add a listed tank mix partner, if desired. 4. Add surfactant if desired. 5. Fill the spray tank with balance of water needed. 6. Continue agitation during Wolverine Advanced Herbicide application to ensure uniform spray coverage.
      Reentry PPE
      PPE required for early entry to treated areas (that is permitted under the Worker Protection Standard and that involves contact with anything that has been treated, such as plants, soil, or water), is the following:\r\n- Coveralls over long-sleeved shirt and long pants\r\n- Socks and chemical resistant footwear\r\n- Goggles or face shield\r\n- Chemical resistant gloves made of barrier laminate, butyl rubber > 14 mils, nitrile rubber > 14 mils, or neoprene rubber > 14 mils
      PPE
      PERSONAL PROTECTIVE EQUIPMENT (PPE) Applicators and other handlers must wear: Long-sleeved shirt and long pants, socks, shoes, chemical resistant gloves made of barrier laminate, butyl rubber > 14 mils, nitrile rubber > 14 mils, or neoprene rubber > 14 mils, and protective eyewear (safety glasses). Follow manufacturer's instructions for cleaning/maintaining PPE. If no such instructions for washables exist, use detergent and hot water. Keep and wash PPE separately from other laundry. Discard clothing and other absorbent materials that have been drenched or heavily contaminated with this product's concentrate. Do not reuse them. Follow manufacturer's instructions for cleaning/maintaining Personal Protective Equipment (PPE). If no such instructions for washables, use detergent and hot water. Keep and wash PPE separately from other laundry.
      Tankmix Compatibility
      COMPATIBILITY TESTING AND TANK MIX PARTNERS Compatibility If Wolverine Advanced Herbicide is to be tank mixed with other pesticides, compatibility should be tested prior to mixing. To test for compatibility, use a small container and mix a small amount (0.5 to 1 qt) of spray, combining all ingredients in the same ratio as the anticipated use. If any indications of physical incompatibility develop, do not use this mixture for spraying. Indications of incompatibility usually will appear within 5-15 minutes after mixing. Read and follow the label of each tank-mix product used for precautionary statements, directions for use, geographic and other restrictions. Tank mixtures For Insect Control Wolverine Advanced Herbicide may be tank mixed with Baythroid(R) XL, Mustang Max(TM), or Warrior(R) insecticides providing proper timing for insect and weed control are the same. Tank mixtures For Disease Control Fungicides such as Stratego(R), Tilt(R), Headline(R), mancozeb(Dithane F-45(R); Manzate(R) 75DF; Penncozeb(R) 75DF), or Topsin(R) M may be tank mixed with Wolverine Advanced Herbicide when timing for application of each tank mix partner is the same for the use site. Do not apply Wolverine Advanced Herbicide in tank mixture with tebuconazole. Tank mix applications of herbicides with fungicides may cause temporary yellowing, leaf burn and or height reduction of the crop. Refer to the specific fungicide label for use directions, application rates, restrictions and a list of diseases controlled.


Recommended Agronomy Resources